BondTech Bondtech Shaft Assembly
This is a replacement component of the Bondtech BMG, SingleDirect and DualDirect extruders, and therefore a useful replacement part to have on hand in the event your extruder components should be damaged. This geared driveshaft is built with a black POM gear press-fit onto a 5mm diameter drive shaft with a flat section ground into it for setscrew attachment of an output gear.
| List Price: | $8.99 |
|---|---|
| Price: | $8.99 |
| Price: | $... |
| Availability: | In Stock |
| Order Now: | Ships Tomorrow |
Have a spare or build your own geared extruder with this Bondtech Driveshaft
This geared driveshaft is built with a black POM input gear press-fit onto a 5mm diameter drive shaft with a flat section ground into it for setscrew attachment of an output gear. This is the primary driveshaft for the Bondtech BMG, SingleDirect and DualDirect extruders, all utilizing 1.75mm filament. If you have a damaged component and need a spare, this is the component to get your extruder back running smoothly. Alternatively, if you are designing your own custom extruder and wish to utilize the top-quality components made by Bondtech, this gear shaft can be a great component in your extruder.
Fully assembled and ready for installation on your Bondtech Extruder
Technical Specifications
- Gear material: POM
- Driveshaft diameter: 5mm
- Compatible Extruders: BMG, SingleDirect, DualDirect
What's in the box?
- Bondtech Shaft Assembly
- M3x2 setscrew for 1.75mm x 0.5mm primary drive gear
Questions
What is the most appropriate soluble support to use with this filament? Would I be correct thinking that HIPS is the best given its higher extrusion temperature (vs PLA)? Thanks in advance - want to ensure I get the right support material when ordering.
I am following the manufacturers guidelines for temp and speed and running into warping that pulls away from the build plate. The printer in inside an enclosure to prevent drafts the build plate is PEI, the printer is a Prusa i3 Mk 3S with a hardened nozzle. Any ideas?
Try a sheet of machinable Garolite LE from McMaster-Carr, which works better for nylon than PEI. E.g., look at this: https://www.mcmaster.com/8474K101 - you could cut and attach it to your build surface. Or you can buy a garolite build surface matched to your printer from Matterhackers.