E3D E3D v6 Block and Sock Upgrade Kit

This is comment and not a question. I just made a set of 3 parts with RYNO for the first time. After 2 tries at getting the temps and speeds set correctly, I made 99.9% perfect prints of all 3 parts in pretty reasonable times on my AnkerMake M5. I was pretty stunned at the results. Really like the results with Pro Series RYNO. For anyone else that needs reference: Fan 100% with fan disabled for first 3 layers. Bed is standard AnkerMake PEI cleaned with alcohol before start of print. Nozzle temp: 245°C Bed temp: 65°C First layer speed: 50 Outer wall speed: 60 Inner wall speed: 80 Sparse speed: 60 Internal solid infill speed: 60 Top surface: 65 Gap infill: 50 Support: 65 Travel: 500 Filament was in dryer for 3-4 hours to get down to 22%RH and ran from dryer with RH between 18-22% during printing.

What are the dimensions of the 5lb spool? When I select the 10lb spool, the dimensions listed under the Technical Specs do not change. I want to make sure the 5lb spool fits in my filament dryer.