UltiMaker UltiMaker 2+ / 3 / S3 Glass Print Bed

This Glass Print Bed is a factory replacement from UltiMaker that fits perfectly on your UltiMaker 2+, UltiMaker 3, or UltiMaker S3. This safety glass is break resistant, but in the event it does break it creates small pieces that are easy to clean up rather than large, dangerous shards.

  • Fits perfectly on UltiMaker 2+, UltiMaker 3, and UltiMaker S3
  • Break resistant
  • Creates small pieces that are easy to clean up
List Price: $53.03
Price: $50.50
Price: $...
Availability: In Stock
Notify me when this is available
Add to wishlist
Product No. M-FHK-AEQK

Official Ultimaker Safety Glass Build Surface

This Glass Print Bed is a factory replacement from UltiMaker that fits perfectly on your UltiMaker 2+, UltiMaker 3, or UltiMaker S3. This safety glass is break resistant, but in the event it does break it creates small pieces that are easy to clean up rather than large, dangerous shards. This is a perfect replacement part to have on hand for all UltiMaker owners, but it can also be used to swap out in between prints for maximum uptime and productivity!

Technical Specifications

  • Glass Size: 9" x 10"
  • Glass Size: 228.6mm x 254mm
  • Machine Compatibility: Ultimaker Original+, Ultimaker 2+, Ultimaker 2 Extended+, Ultimaker 3, Ultimaker 3 Extended, Ultimaker S3

Questions

This is comment and not a question. I just made a set of 3 parts with RYNO for the first time. After 2 tries at getting the temps and speeds set correctly, I made 99.9% perfect prints of all 3 parts in pretty reasonable times on my AnkerMake M5. I was pretty stunned at the results. Really like the results with Pro Series RYNO. For anyone else that needs reference: Fan 100% with fan disabled for first 3 layers. Bed is standard AnkerMake PEI cleaned with alcohol before start of print. Nozzle temp: 245°C Bed temp: 65°C First layer speed: 50 Outer wall speed: 60 Inner wall speed: 80 Sparse speed: 60 Internal solid infill speed: 60 Top surface: 65 Gap infill: 50 Support: 65 Travel: 500 Filament was in dryer for 3-4 hours to get down to 22%RH and ran from dryer with RH between 18-22% during printing.

Add Response

What are the dimensions of the 5lb spool? When I select the 10lb spool, the dimensions listed under the Technical Specs do not change. I want to make sure the 5lb spool fits in my filament dryer.

Add Response

Ask a question about this product

Notify me when this item becomes available

Available Financing

Back to top